Error encountered in: C:\HostingSpaces\weblevel\forums.barrelhorseworld.com\wwwroot\forum\templates\original\fragments\template-begin.asp
Microsoft VBScript compilation error - Expected statement
Martin fender adjustment
Dreamingofcans
Reg. Jan 2011
Posted 2015-04-20 9:42 PM
Subject: Martin fender adjustment



Elite Veteran


Posts: 974
5001001001001002525
Location: USA		 anyone  have an fx3 (or any other martin saddle) and had to slide the fender through the tree some when adjusting the stirrup? I have to adjust mine to the top hole bc I'm short, but I can't slide the dang fender through the tree bars. Does that make sense? It's like getting hooked on something. Any suggestions??
↑ Top ↓ Bottom
BMW
Reg. Jan 2010
Posted 2015-04-20 10:06 PM
Subject: RE: Martin fender adjustment


Expert


Posts: 3147
2000100010025
I didn't have to do it to my Martin, but I had to cut out some of the top of the fenders in order for them to swing more freely.
↑ Top ↓ Bottom
Dreamingofcans
Reg. Jan 2011
Posted 2015-04-20 10:11 PM
Subject: RE: Martin fender adjustment



Elite Veteran


Posts: 974
5001001001001002525
Location: USA		 Well, apparently it's as high as they go. I'm just so darn short I'm not sure my stirrups will fit right. Uuuggghhhhh
↑ Top ↓ Bottom
cheryl makofka
Reg. Jan 2011
Posted 2015-04-20 10:47 PM
Subject: RE: Martin fender adjustment


The Advice Guru


Posts: 6419
50001000100100100100
Call Martin you can send it back and they will shorten the stirrups for you.

When I special ordered mine, I had them make mine 4" shorter
↑ Top ↓ Bottom