Posted 2016-04-18 8:59 AM Subject: On board plexiglass storage ideas
Elite Veteran
Posts: 629 Location: Roping pen
We just upgraded stock trailers to a stock combo.
What does everyone do for on board storage for the plexiglass inserts?
I have always just left them in the barn, but there are times, I would sure like to put them back in while on the road. Trying to figure out a way to hold the 4' pieces in one area and not get them cracked.
Posted 2016-04-18 9:19 AM Subject: RE: On board plexiglass storage ideas
Veteran
Posts: 170 Location: Texas
I've had a living quarters with slats and we only used the stud stall for storage. We would lay them on the floor when not in use. We also had a 3 hrs bumper pull that we added slats too and were able to put them in the tack room up front. It's best to try to lay them flat or they will begin to warp over time. You can always cut them in 1/2 or to a measurement that you can store them in whatever is best for you.
Posted 2016-04-18 9:20 AM Subject: RE: On board plexiglass storage ideas
Expert
Posts: 2674 Location: Silver Lake, MN
I have a stock with lq and I put them under the bed so they would stay flat and be in a safe place they won't break. Is there an option to put them up in the gooseneck?
Posted 2016-04-18 9:52 AM Subject: RE: On board plexiglass storage ideas
I Don't Brag
Posts: 6960
CarrieH77 - 2016-04-18 9:20 AM
I have a stock with lq and I put them under the bed so they would stay flat and be in a safe place they won't break. Is there an option to put them up in the gooseneck?
On board plexiglass storage ideas
